无忧启动论坛

标题: 求助关于凤凰OS适配thinkpad8驱动问题 [打印本页]

作者: 2010eflying    时间: 2017-9-14 12:59
标题: 求助关于凤凰OS适配thinkpad8驱动问题
本帖最后由 2010eflying 于 2017-9-14 16:24 编辑

如题,官方的2.2只支持到触摸,无线,显卡驱动,后来凤凰坛子里适配了声卡驱动,只能是插耳机有声音,外放没解决,后来再用安卓的linux ploy模拟器再安装ubuntu,用ubuntu的alsa模块改到了可以外放有声音,耳机有声音,但是插入耳机外放不能关闭,不能自动切换到耳机模式,哪位大神能解决,特此跪求高手解决!
作者: 窄口牛    时间: 2017-9-14 15:32
本帖最后由 窄口牛 于 2017-9-14 16:49 编辑

买个USB声卡
作者: 2010eflying    时间: 2017-9-14 16:17
坑爹,我只说没支持到声卡而已,现在声显卡网触全支持了,因是耳机和外放不能控制
作者: 2010eflying    时间: 2017-9-14 22:33
wintoflash 发表于 2017-9-14 17:53
驱动可能有bug。
为啥不去凤凰论坛问原作者?

原作者只说到时联系我,太神你那个Porteus在TP8上能运行,只是没网卡驱动和声卡驱动,能适配么?
作者: 2010eflying    时间: 2017-9-14 23:15
本帖最后由 2010eflying 于 2017-9-15 00:59 编辑

wintoflash 发表于 2017-9-14 22:40
发一下你的网卡和声卡的型号.


http://bbs.phoenixstudio.org/cn/ ... 12&page=1#49617
作者: 2010eflying    时间: 2017-9-15 10:11
wintoflash 发表于 2017-9-15 09:48
你用的linux是64位的还是32位的?

64位的
作者: 2010eflying    时间: 2017-9-15 19:32
看能解决不?我发出那个凤凰os网址也是用alsa驱动的,现在耳机能正确播放了,外放也能播放了,只是插耳机不能切换到耳机模式
作者: 窄口牛    时间: 2017-9-15 20:08
卖了重买一台
作者: 2010eflying    时间: 2017-9-15 23:48
窄口牛 发表于 2017-9-15 20:08
卖了重买一台

你够坑的啊,你是土豪我是屌丝
作者: 窄口牛    时间: 2017-9-16 06:42
有的机器确实没办法,你这几天已经看到了,不一定是没人搞,可能就是搞不定。
作者: 窄口牛    时间: 2017-9-16 06:43
最起码linux装上都能正常,这种就能搞,否则可能就确实是不行。
作者: 2010eflying    时间: 2017-9-17 02:58

00:00.0 Host bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series SoC Transaction Register (rev 0d)
        Subsystem: Lenovo Device 221c
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Kernel driver in use: iosf_mbi_pci

00:02.0 VGA compatible controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Graphics & Display (rev 0d) (prog-if 00 [VGA controller])
        Subsystem: Lenovo Device 221c
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin A routed to IRQ 263
        Region 0: Memory at d0000000 (32-bit, non-prefetchable) [size=4M]
        Region 2: Memory at c0000000 (32-bit, prefetchable) [size=256M]
        Region 4: I/O ports at 1000
        [virtual] Expansion ROM at 000c0000 [disabled] [size=128K]
        Capabilities: [d0] Power Management version 2
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [90] MSI: Enable+ Count=1/1 Maskable- 64bit-
                Address: fee0f00c  Data: 41e3
        Capabilities: [b0] Vendor Specific Information: Len=07 <?>
        Kernel driver in use: i915
        Kernel modules: i915

00:14.0 USB controller: Intel Corporation Atom Processor Z36xxx/Z37xxx, Celeron N2000 Series USB xHCI (rev 0d) (prog-if 30 [XHCI])
        Subsystem: Intel Corporation Device 7270
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin A routed to IRQ 261
        Region 0: Memory at d0800000 (64-bit, non-prefetchable) [size=64K]
        Capabilities: [70] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot+,D3cold+)
                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [80] MSI: Enable+ Count=1/8 Maskable- 64bit+
                Address: 00000000fee0f00c  Data: 4173
        Kernel driver in use: xhci_hcd

00:1a.0 Encryption controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Trusted Execution Engine (rev 0d)
        Subsystem: Intel Corporation Device 7270
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx+
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin A routed to IRQ 262
        Region 0: Memory at d0700000 (32-bit, non-prefetchable) [size=1M]
        Region 1: Memory at d0600000 (32-bit, non-prefetchable) [size=1M]
        Capabilities: [80] Power Management version 3
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold-)
                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [a0] MSI: Enable+ Count=1/1 Maskable- 64bit-
                Address: fee0f00c  Data: 41c3
        Kernel driver in use: mei_txe
        Kernel modules: mei_txe

00:1f.0 ISA bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Power Control Unit (rev 0d)
        Subsystem: Intel Corporation Device 7270
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Capabilities: [e0] Vendor Specific Information: Len=0c <?>
        Kernel driver in use: lpc_ich
        Kernel modules: lpc_ich






欢迎光临 无忧启动论坛 (http://bbs.wuyou.net/) Powered by Discuz! X3.3