|
|
原帖由 songhangzhou 于 2010-6-25 15:53 发表 
Image我用的是2.51的,不知更新了啥?
Image的兼容性很好,没出过错误,同时也支持EISA,HPA等隐藏分区...
Image for Windows: Upgrade History
* Version 2.57 - Jun 11, 2010
* Added EXT4 support for file access and resizing.
* Support alternate hard drive physical sector sizes up to 4KiB.
* Change to notify Windows of deleted partitions when /clr used and restore fails.
* PHYLock updated to V6 (required for 2.57) - upgrade will require reboot.
* TBIView/TBIMount updated to support alternate sector sizes up to 4KiB.
* Other Misc.
* Version 2.56 - May 12, 2010
* Fixed potential crash on multi-pass differential backup when lots of fragmentation and not many changes.
* Added NLRM advanced option.
* Other Misc.
* Version 2.55a - Apr 9, 2010
* Added support to provide NT Disk Signature on /F and /BASE option via # modifier.
* Fixed change in 2.55 which prevented running in Windows 98.
* Version 2.55 - Apr 6, 2010
* Added support to provide NT Disk Signature on /D option via # modifier.
* Other Misc.
* Version 2.54 - Mar 5, 2010
* Improved support for dealing with non-partitioned devices.
* Added new /MD (MakeDir) option to have target path automatically created.
* Added new /CSIG (ChangeNTSig) option for full drive copies and restores.
* Added option to use Volume Shadow Copy Service (VSS) on Windows 2003 or later.
* Other Misc.
* Version 2.53 - Jan 24, 2010
* Fixed copy of single item to correctly determine if it will fit in target selected location.
* Added new /PHC (PageHiberClear) option to clear part of or truncate page or hibernation file.
* Added new /FNTS (ForceNTSig) option to force NT signature to not be changed by windows so a HD with a duplicate signature can be removed an installed in another system.
* Other Misc.
* Version 2.52 - Dec 8, 2009
* Adjusted scaling to prevent a potential target not large enough message when scaling to larger drive.
* Added /NOS (NoScale) option to prevent scaling of small partitions.
* Added new set of global geometry settings (/geodis, /geoahs, /geoa2k, /geombr, /geombrv, /geoorg) for easy control and with defaults set to prevent common problems user run into.
* Added new /w7mbr (Win7MBR) option to change the standard mbr code used to the Windows 7 compatible version.
* Added new /mgv (UseValidMBRGeoOnly) option to extend the logic used with the /mg (UseMBRGeo) option.
* Added new /uggs (UseGlobalGeoSettings) option to support overriding of new global geometry settings.
* Added support to write directly to partially hidden volumes under Win7.
* Added support for UFD spanning of volumes with no drive letters.
* Added Preserve Key for Writable Media option to PEBuilder Plug-In to set imagew.ini as read-only. If imagew.ini is not read-only and BartPE is on writable media (UFD for example) the key will be cleared and unavailable for the next boot.
* Updated PHYLock setup to move PartMgr after phylock or PHYLock writes to the disk cache are blocked (PHYLock Error 7).
* Documented /po (PerfOpt) in manual.
* Added /min option to start minimized.
* Added advanced /noosn option to defer partition change notifications to the OS.
* Added advanced /irlm option to ignore locking of particular drive letters.
* Other Misc.
* Version 2.51a - Oct 29, 2009
* Updated AUTO restore first track option for GRUB2.
* Fixed problem introduced in 2.50 where disk signature was not being restored with first track when first partition on source disk was located at or above LBA 128.
* Changed PEBuilder Plug-In to look for new cdboot.ifd name instead of cdboot.ins.
* Corrected prompts that may reference 64bit numbers.
* Other Misc.
____________
http://www.terabyteunlimited.com/upgradehist-image-for-windows.htm
[ 本帖最后由 andos 于 2010-6-26 14:32 编辑 ] |
|
IP卡
狗仔卡
发表于 2009-12-13 00:28:31
显身卡
楼主
