老毛桃大哥:请教GRUP0.97怎么安装(发这里不知对不对,不要见怪)

go2

我下了你的GRUB0.97
MENU.LST里有个

title install GRUB on (hd0,0) to MBR (hd0) and reboot. Password: danger
pause You requested to install GRUB onto MBR. We highly recommend you NOT to do so, basically for two reasons: 1. For some non-MS-compatible boot loaders(in case you might be using), the install is INDEED dangerous and may cause your whole disk(and all your operating systems on it) unaccessible. 2. Even if you are using(in MBR)an MS-compatible boot loader such as LILO and GRUB, you may encounter problems like hard-disk-boot-failure when you move or delete the /boot/grub/stage2 file, or even when disk defragmentation operations are made. Press any key to continue...
pause A password prompt will confirm that you want the operation anyway. Press any key to continue...
password danger
pause This will install GRUB in (hd0,0)/boot/grub/ to MBR. Press any key to begin...
root (hd0,0)
setup (hd0)
pause GRUB install OK! Press any key to reboot your machine...
reboot

我用这个安装了GRUB菜单启动。一次我把C盘转换成NTFS，结果就进不了菜单，后来我进到DOS下用GRUB.EXE下把你原来的MENU.LST覆盖到我改过的MENU.LST后，再用以上重新安装了GRUB才得以解决。

在这里我想请教一下，我在DOS下运行GRUB.EXE后，用什么命令来安装？

菜鸟请教！

老毛桃

晕，你将 Grub 写入了 MGR，当然会出问题，没看到第一行写着 Danger 吗？

go2

我的意思是：
虽然出问题了，但我可以在DOS下运行GRUB.EXE
就可以进入GRUB菜单了。。。
那么我在这个菜单下用哪个命令把GRUB重新写入MGR中了

go2

试了一下，几这个命令
root (hd0,0)
setup (hdo)

我怎么没看到

....
pause This will install GRUB in (hd0,0)/boot/grub/ to MBR. Press any key to begin...
root (hd0,0)
setup (hd0)
pause GRUB install OK! Press any key to reboot your machine...
reboot

[ 本帖最后由 go2 于 2006-9-28 10:08 PM 编辑 ]